Nicd/Nimh; Nicd/Nimh - Charge Modes; Nicd/Nimh - Charge Mode; Nicd/Nimh - Auto Charge Mode - HITEC X1 Pro Bedienungsanleitung

8. NiCd/NiMH

This program is only suitable for charging/discharging
NiCd/NiMH batteries.

8.1. NiCd/NiMH - Charge Modes

The X1Pro offers the following NiCd/NiMH charge modes:
Charge, Auto Charge, Discharge, Re-Peak and Cycle.
Before selecting a charge mode, it is critical
that you select the correct type of lithium
battery to be charged. Failure to do so can
result in damage to the battery and possible
explosion.

8.2. NiCd/NiMH - Charge Mode

Before you begin charging your battery, make
sure you have read and understand all of the
warnings and safety information.
Toggle right
NiMH CHARGE
CURRENT 1.6A
rate value will begin fl ashing.
Toggle up or down to adjust the value to the desired
rate. Follow the instructions provided with your battery
when setting the amp rate. Toggle and hold the joystick to
the right for three seconds to begin charging.

8.3. NiCd/NiMH - Auto Charge Mode

In this program the charger detects the condition of the
battery connected to the output and automatically charges
the battery. In this mode, you should set up the upper limit
of the charge current to avoid damage by feeding excessive
current. Some batteries of low resistance and capacity can
lead to higher current in the Auto Charge mode.
Before you begin charging your battery, make
sure you have read and understand all of the
warnings and safety information.
38
Professional Balance Charger, Discharger
Selecting a Battery Type
PROGRAM SELECT
to the "
enter the "
or down
charge. Now, toggle right
" NiCd
" CHARGE
NiMH 1.6A 5.96V
CHG 003:43 00090
real-time information: battery type, charging current, battery
voltage, charging time and charged capactiy.
Once the battery is fully charged the screen will read
once and the amp
" END:FINISHED
sound. Toggle left
left at any time during the charging process to stop
charging.
Select the correct battery type by following the instructions
on page 38. Once you have set the correct battery type,
toggle up
CHARGE
NiMH Auto CHARGE
CURRENT 5.0A
Toggle up
rate. Follow the instructions provided with your battery
when setting the amp rate. Toggle and hold the joystick to
the right
When you power on the X1 Pro
NiMH BATT
you will automatically be taken
LIPO BALANCE " screen. Toggle left
"screen. Toggle up
PROGRAM SELECT
until you see the battery type you wish to
once to enter the "
" Program. The default charge mode will be
".
Once charging has commenced, the
charger will display the following
" and the charger will emit a chiming
once to stop charging. You may toggle
or down until you see the "
" screen.
Toggle right
rate value will begin fl ashing.
or down to adjust the value to the desired
for three seconds to begin charging.
once to
NiMH " or
NiMH Auto
once and the amp