Lithium - Balance Charge Mode - HITEC X1 Pro Bedienungsanleitung

7.3. Lithium - Balance Charge Mode

This function is for balancing the voltage of individual
lithium-polymer battery cells while charging. In order to
use the Balance Mode, the battery must have a balance
lead. Charging in this mode is different from the normal
mode because the built-in processor monitors the voltage
of each individual cell and controls the input current fed
into each cell in order to equalize the voltage.
See page 31 for the appropriate charging connections
setup for this operation.
First, select the correct battery
LiPo BALANCE
8.1A 22.2V(6S)
type by following the instructions
on page 31. Once you have set the correct battery type,
toggle up or down until you see the "
BALANCE " screen.
Toggle right
LiPo BALANCE
0.8A 22.2V(6S)
rate value will begin fl ashing.
Toggle up or down to adjust the value to the desired
rate. Follow the instructions provided with your battery
when setting the amp rate.
Toggle right
LiPo BALANCE
0.8A 11.1V(3S)
count value will begin fl ashing.
Toggle up or down to adjust the cell count. This will
automatically change the voltage value to the correct
setting for the selected cell count. The cell count should
exactly match the battery label.
Toggle and hold the joystick to the right
seconds and you will see " BATTERY CHECK WAIT...
followed by the " CONFIRM/CANCEL
This screen displays the number
R:3SER S:3SER
CONFIRM(ENTER)
of cells you set up as "
the number of cells detected by the processor as "
both numbers are identical, you may toggle right
to confi rm and begin charging. If the cell count does not
match, toggle left once to return to the previous screen
and carefully check the number of cells of the battery pack
before proceeding.
34
Professional Balance Charger, Discharger
Use of a balance adaptor with any battery that has a
balance lead will improve the performance and lifespan of
the battery.
Li3s 1.2A 12.69V
BAL 022:43 00682
real-time information: battery type/cell count, charging
current, battery voltage, charging time and charged capactiy
LiPo
once and the amp
4.09 4.09V 4.09V
0.00 0.00V 0.00V
each individual cell.
again and cell
Once the battery is fully charged the screen will read
" [END:FINISH]
sound. Toggle left
left at any time during the charging process to stop
charging.
for three
"
" screen.
R " and
S ". If
once
Before you begin charging your battery, make
sure you have read and understand all of the
warnings and safety information.
Once charging has commenced, the
charger will display the following
During charging, the battery should be placed
inside a fi reproof/retardant bag and on a fi re
proof surface, away from other combustible
objects.
During charging you may toggle
up once to view the voltage of
" and the charger will emit a chiming
once to stop charging. You may toggle