Warnings And Error Messages - HITEC X1 Pro Bedienungsanleitung

Professional Balance Charger, Discharger
13. System Set Up
The battery temperature reading requires a temperature
sensor that is sold seperately.
Toggle and hold the joystick to the right
seconds to load the factory settings.

14. Warnings and Error Messages

REVERSE POLARITY
The battery/charger connections (red/black) are reversed.
CONNECTION BREAK
The battery connection has been diconnected.
CONNECT ERROR
The battery connection is wrong.
CHECK MAIN PORT
BALANCE CONNECT
The balance connection is wrong.
ERROR
DC IN TOO LOW
The input voltage is less than 11V.
DC IN TOO HIGH
The input voltage is higher than 18V.
CELL ERROR
The voltage of one cell in the battery pack is too low.
LOW VOLTAGE
CELL ERROR
The voltage of one cell in the battery pack is too high.
HIGH VOLTAGE
CELL ERROR
The voltage of one cell in the battery pack is invalid.
VOLTAGE INVALID
CELL NUMBER
The cell count is wrong.
INCORRECT
INT. TEMP . TOO
The internal temperature of the charger is too high.
HIGH
EXT. TEMP . TOO
The external temperature of the charger is too high.
HIGH
OVER CHARGE
The battery capacity is higher than the maximum set by the user.
CAPACITY LIMIT
OVER TIME LIMIT
The charging time is higher than the maximum set by the user.
BATTERY WAS FULL
In balance mode, the battery voltage is higher than the maximum set by the user.
Version
VERSION
for three
This screen shows the version
1.00
number.
45