Lithium - Storage Mode - HITEC X1 Pro Bedienungsanleitung

7.5. Lithium - Storage Mode

This function is for charging/discharging batteries that will not
be used immediately. The program is designed for charging/
discharging batteries up-to or down-to safe storage levels.
Before you begin charging your battery, make
sure you have read and understand all of the
warnings and safety information.
See page 31 for the appropriate charging connections
setup for this operation.
First, select the correct battery
LiPo STORAGE
8.1A 22.2V(6S)
type by following the instructions
on page 33. Once you have set the correct battery type, toggle
up or down until you see the "
Toggle right
LiPo STORAGE
0.8A 22.2V(6S)
rate value will begin fl ashing.
Toggle up or down to adjust the value to the desired
rate. Follow the instructions provided with your battery
when setting the amp rate.
Toggle right
LiPo STORAGE
0.8A 11.1V(3S)
count value will begin fl ashing.
Toggle up or down to adjust the cell count. This will
automatically change the voltage value to the correct
setting for the selected cell count. The cell count should
exactly match the battery label.
Toggle and hold the joystick to the right
and you will see " BATTERY CHECK WAIT...
by the " CONFIRM/CANCEL
This screen displays the number
R:3SER S:3SER
CONFIRM(ENTER)
of cells you set up as "
the number of cells detected by the processor as "
both numbers are identical, you may toggle right
to confi rm and begin charging. If the cell count does not
match, toggle left once to return to the previous screen
and carefully check the number of cells of the battery pack
before proceeding.
36
LiPo storage " screen.
once and the amp
again and the cell
for three seconds
" followed
" screen.
R " and
S ". If
once
Professional Balance Charger, Discharger
The program will automatically begin to discharge if the
current state of the battery exceeds the voltage level for
storage.
In the Storage Mode, lithium batteries can be
charged without the use of a balance adaptor.
A balance adapter can be used, but it is not
required. balance charge mode is recommended
for any battery with a balance lead.
Once charging has commenced,
Li3s 1.2A 12.69V
STO 022:43 00682
the charger will display the
following real-time information: battery type/cell count,
charging current, battery voltage, charging time and
charged capactiy.
During charging, the battery should be placed
inside a fi reproof/retardant bag and on a fi re
proof surface, away from other combustible
objects.
During charging you may toggle
4.09 4.09V 4.09V
0.00 0.00V 0.00V
up
each individual cell.
Once the battery charge has reached storage level the
screen will read " [STORAGE FINISHED]
charger will emit a chiming sound. Toggle left
stop charging. You may toggle left
the charging process to stop charging.
once to view the voltage of
" and the
once to
at any time during