Power Supply Connections - HITEC X1 Pro Bedienungsanleitung

Professional Balance Charger, Discharger

4. Power Supply Connections

To avoid short circuits, always connect the
charge leads to the charger fi rst, and then
to the battery. Reverse the sequence when
disconnecting. Never let the ends of the
positive and negative wires touch.
XT60 Connector plugged directly to charger.
To utilize the charger's absolute maximum power capabilities,
the DC power source must be capable of delivering at least
17 amps while maintaining 12 V DC.
This charger is powered by an 11-18 V DC power source.
There are two pair of dc input sockets; one is used for the
connection of a DC power cord (XT60 type connector) and
is located on the right side of the charger. The other is used
for docking into the epowerbox 17A power supply and is
located on the bottom of the charger. This socket accepts
bananna plug type connectors.
Bullet connectors plugged directly to power supply.
X1 Pro
Dual
Bananna
Plugs
ePowerBox 17A
31