Replacing The 8K2 External Fan - Fronius Symo 3.0-3-S Serviceanleitung

(3)
Replacing the 8k2 Removing the External Fan:
External Fan
90
(3) (6) (4)
(2) (1)
NOTE!
Ensure the air is flowing into the
device!
Snap the new external fan into the air
1
duct
Place the air duct on the rear of the
2
inverter
Thread in the fan cable and press in
3
the seal plugs (4)
WARNING!
The seal plugs must be completely
inserted in order to ensure leak-tight-
ness
Snap in the locks (6) for the air duct
4
on both sides
Mount the air duct using two 5x14
5
TX25 screws (3)
[2.15 Nm]
NOTE!
Carefully turn the inverter around.
Plug in the fan cable (1) on the Symo-
6
FIL and insert into the cable guide (2)
Close the inverter and place it in the
7
wall bracket (see "Opening and Clo-
sing the Device")
After switching on the inverter, carry out a
fan test via the display (see Operating
Instructions)