Fronius Symo 3.0-3-S Serviceanleitung Seite 85

(4)
(4)
Closing the Device:
NOTE!
2
To avoid damage to the base shell, the
inverter must not exceed an angle of
11°.
Wait for the capacitors to discharge
before continuing.
1
Lift the inverter from the Datcom area,
5
disconnecting the connection to the
wall bracket
Lift up and detach the inverter
6
Loosen the four 5x18 TX25 screws
7
including gaskets (4) and lift off the
power stage set cover
(4)
(4)
NOTE!
To ensure a sufficient EMC connection
is established, all EMC springs must be
present
Check the correct position of the ten
1
EMC springs – the EMC springs are
held in place by small indentations
WARNING!
85