Replacing other
components
Follow the safety rules (see start of "Safety" chapter)
If the following components are faulty, the complete inverter must be replaced:
-
-
-
-
The lids (DATCOM lid and power module lid) can be replaced as an assembly with
sprayed seal.
(1)
(2)
(3)
WARNING!
Housing parts (except lid)
Inductors
Heat sink
Seals (except the seal on the lids)
Thread in and connect all cables and
4
plug connections (1)-(4)
NOTE!
Ensure that the ferrite cores and their
holders are fitted correctly
Close the inverter and place it in the
5
wall bracket (see "Opening and Clo-
sing the Device")
(4)
After switching on the inverter, carry
6
out a fan test via the display (see Ope-
rating Instructions)
107