MBO Merkura 1050 Gebrauchsanweisung Seite 38

Merkura 1050 GB neu
14
C
C
www.MBOservice.net
Downloaded from www.Manualslib.com
27.03.2003
USING THE PULSE COMPUTER
1. Setting the alarm zone
In pulse mode, keep pressing key "B" until the
letters ZN are displayed in the centre line of the
display. Press and hold down key "C" until the
Z
O symbols for the upper and lower training limits
N
E
Use key "B" to select one of the following
zones:
B
After setting the alarm zone, press key "C" to
switch to training zone selection mode.
2. Selecting the training zone
After switching to training zone selection mode,
the currently selected training zone (1, 2, 3 or U)
in square brackets starts to flash. The relevant
Z
upper and lower limits also flash in the bottom
O
N
E
line. You can switch between the 4 training
zones by pressing key "B". Confirm your selec-
tion with key "C". This completes the alarm zone
B
selection process.
Note:
You must set the alarm zone before selecting the
training zone.
manuals search engine
8:31 Uhr
start to flash.
Alarm only when you exceed the training
zone – 2 beeps per second
Alarm only when you fall below the
training zone – 1 beep per second
Alarm when the pulse is outside the
training zone
Seite 14