Galvamet KompaKTech Bedienungs- Und Wartungsanleitung Seite 124

EN
The appliance is composed by three devices that must be separately connected to the
electricity: the serial plates stating the electricity supply needed are located under each
side of the induction hob and on the upper aspiration unit.
Connection must be carried out by means of connection cables model H05V2V2-F,
following the instructions on the table below:
LINE L
EARTH
NEUTRAL N
 After the connection switch the induction hob for about 3 minutes to make sure it
is operating correctly.
 Connection cable on the back sides of the appliance should NOT touch the appliance
back side, as this part will get very hot during operation.
Upon each connection to the power supply the sensors of the appliance are automatically
adjusted to ensure their proper function.
During this process all displays turn on and are lighted on for a few seconds.
During the adjustment procedure the sensors must be free of any objects, otherwise the
adjustment procedure will be interrupted.
During this process the use of the appliance is not possible.
BROWN
YELLOW/GREEN
BLUE
48