Installation On Up To 660 Mm Deep Bases - Galvamet KompaKTech Bedienungs- Und Wartungsanleitung

EN
III.2 INSTALLATION ON UP TO 660 mm DEEP BASES
In the box the technician will find the elements shown on Fig. 3.6.
Elements must be mounted carefully following the procedure described in this guide.
The replacement fitting identified with "2" by a
marking on the back is not useful in this installation.
The device dimensions after installation are shown
at Fig. 3.7
The dimensions refer to the axis of the induction hob
and involve a specific configuration of the piece of
furniture, of the drawers that may be present and of
their own dimensions.
Fig. 3.7
10