Pause Function; Recall Function - Galvamet KompaKTech Bedienungs- Und Wartungsanleitung

EN

PAUSE FUNCTION

The execution of the function is only possible if at least one cooking zone is operating.
The pause can also be activated with specific errors of the cooking zones, the error is
hidden; also the indication of residual heat, special messages like
The pause has priority. If there is a generic error during the pause, the control will switch
off and the mode will end.
Activation
Touch for 1 second at least, the related LED switches on and all the displays show
During the function
The timers already programmed before the pause (even the alarm timer) are blocked
during the pause and continue when the function ends.
The automatic heating and the booster function are switched off.
The calculation of residual heat and the limitation of the operating time continue.
The other LED functions (timer, multi-circuit, etc.) continue to be lit according to the
status.
The Function can last max. 10 minutes.
The hob can be switched on or off at any time by touching
pause mode is deactivated.
Deactivation
Touch . The LEDs above the cursor of one of the cooking zones light up.
Within 10 seconds, touch and scroll, from left to right, on the slider of the illuminated area.
The LED above the pause button goes out and the condition before the pause mode is re-
established.

RECALL FUNCTION

Using this function the settings can be saved quickly when, by mistake, the control is
switched off by touching
After switching off, the operator has 6 seconds to turn the control back on and another 6
seconds to touch
This function can only be used if at least one cooking zone is active (cooking level> 0),
regardless of whether the block function is active or not.
.
, or , are hidden.
. In this case the active
.
55