Troubleshooting; Service Information; Possible Cause - Scheppach PL55 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

The packaging is wholly composed of environment ally-friendly materials that can be disposed of at a local recycling
centre.
Contact your local refuse disposal authority for more details of how to dispose of your worn out electrical devices.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed of at a designated
collection point. This can occur, for example, by handing it in at an authorised collecting point for the recycling of waste electrical and
electronic equipment. Improper handling of waste equipment may have negative consequences for the environment and human health
due to potentially hazardous substances that are often contained in electrical and electronic equipment. By properly disposing of this
product, you are also contributing to the effective use of natural resources. You can obtain information on collection points for waste
equipment from your municipal administration, public waste disposal authority, an authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company..

15. Troubleshooting

Problem
The motor does not run.
The motor starts slowly and does
not reach running speed.
Excessive motor noise.
The motor does not reach full
power.
Motor overheats easily
Decrease in cutting power when
sawing
The saw cut is rough or wavy
The work piece rips or splinters

Service information

Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also
required for use as consumables.
Wear parts*: Carbon brush, saw blade
* Not necessarily included in the scope of delivery!
38 IE/NI

Possible Cause

Faulty motor, power supply cable or plug.
Burned out fuses.
Low power supply voltage. Damaged wind-
ings. Burned out capacitor.
Damaged windings. Faulty motor.
Overloaded circuit due to lighting, utilities or
other motors.
Overload of the motor; inadequate cooling
of the motor
The saw blade is too small (sharpened too
often)
The saw blade is dull; the tooth shape is not
suited to the thickness of the material
The cutting pressure is excessive or the saw
blade is not suited to the application
Help
Have the machine checked by skilled personnel. Do not
try to repair the machine yourselves as it may be danger-
ous. Check the fuses and replace them if necessary.
Ask for the Electricity Board to check the voltage avail-
able. Have the machine motor checked by skilled person-
nel. Have the capacitor replaced by skilled personnel.
Have the motor checked by skilled personnel.
Do not use other utilities or motors on the circuit to which
the track saw is connected.
Prevent overloading the motor when cutting; remove dust
from the motor to ensure an optimum cooling of the motor
Re-adjust the end stop of the saw unit
Re-sharpen the saw blade or use an appropriate saw
blade
Use the correct saw blade