Troubleshooting - Scheppach DECO FLEX SL Original Bedienungsanleitung

Do not throw primary batteries or rechargeable
batteries away with household waste
As the consumer you are required by law to
bring all batteries and rechargeable batteries,
regardless whether they contain harmful sub-
stances* or not, to a collection point run by the local
authority or to a retailer, so that they can be disposed of
in an environmentally friendly manner.
*labelled with:
Cd = cadmium, Hg = mercury, Pb = lead
Remove the batteries from the laser before disposing
of the device and the batteries.

15. Troubleshooting

WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Saw blade without pins
loosens after switching
off the engine
Motor does not start
Saw blades brake
Saw blade oscillates,
not aligned straightly.
Possible cause
Saw blade clamping screw of the
tool receiver (27) not tightened
enough
Extension cable defective
Connection to the motor or switch
not OK
Motor or switch faulty
Tension set incorrectly
Load too high
Incorrect saw blade type
Workpiece not fed straightly
Holders not aligned
www.scheppach.com
Remedy
Tighten the saw blade clamping screw of the
tool receiver (27)
Replace the extension cable
Have this checked by an electrician
Have this checked by an electrician
Set correct tension
Feed workpiece more slowly
Use correct saw blades
Avoid lateral pressure
Open the screws that fasten the holders.
Bring the holders into the vertical position
and tighten the screws again.
GB | 39