Troubleshooting - Scheppach HS100S Original Bedienungsanleitung

• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.

16. Troubleshooting

Problem Possible cause
Saw blade gets
loose after turning Fixing nut not tight enough
off the motor
Mains fuse blown
Extension cable defect
Motor does not start
Connections to the motor or switch
not OK
Motor or switch defective
Cross section of the extension cable
Motor not supplying
insufficient
power, fuse tripping
Overload due to blunt saw blade
Blunt saw blade
Burn areas at the
cutting surface
Wrong saw blade
42 | GB
Help
Tighten fixing nut with right-hand thread
Check the mains fuse
Replace the extension cable
Have it checked by an electrician
Have it checked by an electrician
See "Electrical Connection" in the operating
manual
Replace saw blade
Sharpen saw blade, replace
Replace saw blade
www.scheppach.com