Troubleshooting - Scheppach HS110 Bedienungs- Und Sicherheitshinweise

The packaging is wholly composed of environmentally-friendly materials that can be disposed of at a local recycling
centre.
Contact your local refuse disposal authority for more details of how to dispose of your worn-out electrical devices.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed of at a designated
collection point. This can occur, for example, by handing it in at an authorised collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste equipment may have negative consequences for the environment and human
health due to potentially hazardous substances that are often contained in electrical and electronic equipment. By properly disposing of
this product, you are also contributing to the effective use of natural resources. You can obtain information on collection points for waste
equipment from your municipal administration, public waste disposal authority, an authorised body for the disposal of waste electrical and
electronic equipment or your waste disposal company.

17. Troubleshooting

Fault Possible causes
Blade dissolves after To slightly tightened fastening nut
switching off the engine
Engine will not start Failure mains fuse
Defective extension cable
Connections on motor or switch not in order
Motor or switch faulty
Motor will not work, the Cross section of the extension cable is not
fuse is active sufficient
Overload by a blunt saw blade
Fire marks on the cutting Blunt saw blade
surface
Wrong saw blade
14 GB/CY
Action
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
See „Electrical connection"
Change saw blade
Have saw blade sharpened (only by an authorised
sharpening specialist) or change it
Change saw blade