Troubleshooting - Scheppach HBS261 Original Bedienungsanleitung

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.

15. Troubleshooting

Problem
Motor does not work
The motor starts up slowly and
does not reach operating speed.
Motor makes excessive noise
The motor does not reach its
full power.
Motor overheats easily.
Saw cut is rough or wavy
Workpiece pulls away and/or
splinters
Saw blade is not running
straight
Burn marks appear on the wood
during the cutting work
Saw blade jams during cutting
work
Possible cause
Motor, cable or plug defective,
fuses burnt
Housing cover open (limit switch)
Voltage too low, coils damaged,
capacitor burnt
Coils damaged, motor defective
Circuits in the network are over-
loaded (lamps, other motors, etc.)
Overloading of the motor, insuffi-
cient cooling of the motor
Saw blade dull, tooth shape
not appropriate for the material
thickness
Excessive cutting pressure and/or
saw blade not suitable for use
Guide has been wrongly set
Wrong saw blade
Blunt saw blade
Wrong saw blade
Blunt saw blade
Deposits on the saw blade
Guide has been set poorly
www.scheppach.com
Help
Arrange for inspection of the machine by
a specialist. Never repair the motor your-
self. Danger! Check fuses and replace as
necessary
Close housing cover exactly
Contact the utility provider to check the
voltage. Arrange for inspection of the mo-
tor by a specialist. Arrange for replace-
ment of the capacitor by a specialist
Arrange for inspection of the motor by a
specialist
Do not use any other equipment or mo-
tors on the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to
ensure optimal cooling of the motor
Resharpen saw blade and/or use suitable
saw blade
Insert suitable saw blade
Set the saw blade guide according to the
operating instructions
Select a saw blade according to the
operating instructions
Change the saw blade
Select a saw blade according to the
operating instructions
Change the saw blade
Clean the saw blade
Set the saw blade guide according to the
operating instructions
GB | 37