Disassembly - Abicor Binzel xFUME ADVANCED Betriebsanleitung

11 Disassembly

11 Disassembly
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the extraction system.
• Close off the compressed air supply.
• Disconnect all electrical connections.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Check and wear your personal protective equipment.
• Persons without personal protective equipment must not remain near the extraction system when it is being
disassembled.
• The extraction system must not be cleaned using compressed air or a hammer.
To disassemble and dispose of the device, follow the steps in sections 6 and 7 in reverse order.
 6 Putting into operation on page EN- 9
 7 Operation on page EN- 12
Dispose of the components in accordance with legal regulations.
 12 Disposal on page EN- 19
EN - 18
xFUME ADVANCED
BAL.0731.0 • 2020-07-14