Disassembly - Abicor Binzel ABIDRIVE 2 Betriebsanleitung

TIG cold-wire feeder

11 Disassembly

Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Switch off the entire welding system.
• Disconnect the mains plug.
Risk of burns
Risk of burns from hot coolant and hot surfaces.
• Switch off the cooling unit before starting maintenance, servicing, assembly, disassembly or repair
• Wear protective gloves.
Risk of crushing
Upper limbs can be crushed or caught by the covering hood.
• Do not reach into the danger zone.
• Wear protective gloves.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany see TRBS 1203).
• Please consult the operating instructions for the welding components, such as the welding power
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-27.
Disassemble the ABIDRIVE V2 using the following procedure:
1 Disassemble the intermediate cable assembly.
2 Disassemble the cable assembly along with cold-wire feeder.
DANGER
DANGER
work.
WARNING
source and the robot control unit.
11 Disassembly
EN - 31