Selecting The Function Type En; Selecting The Parameters En - Abicor Binzel ABIDRIVE 2 Betriebsanleitung

TIG cold-wire feeder
Depending on the default settings, the knob (5) can be used to increase or decrease the values.
6.3.1 Selecting the function type
1 Function type: 2-cycle
2 Function type: 4-cycle
Fig. 6 Function type selection
Press the selection button (4) to switch between the function types 2-cycle, 4-cycle and
2/4-cycle with interval.
6.3.2 Selecting the parameters
1 Wire feed rate (SPE)
2 Wire feed delay time (dt)
Fig. 7 Parameter selection
Press the selection button (6) to select the individual functions.
The functions are shown by the display indicators.
 Fig. 5 Front panel display on page EN-12
3 Function type: with interval (2 or 4-cycle)
3 Wire retraction time (rE)
4 Wire feed with interval (ton)
6 Putting into operation
1
2
3
4
4 Function type selection button
1
2
3
4
5
6
5 Wire feed interval break (tot)
6 Parameter selection button
EN - 13