System Master Sheet; Manufacturer; Purpose; Changes To The Design / Construction - Nussbaum ATT TOP LIFT 2.35 TS Betriebsanleitung

2

System master sheet

2.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2

Purpose

The lift is a lifting tool for raising vehicles up to a total weight or 3500 kg, for a maximum lift distribution of 2:3
in the drive-in or against the drive-in direction. The lift is not set up for standing on the fixture or for personnel
conveyance.
Lift versions:
TOP LIFT 2.35 TS = HYMAX Inground 2.35 R = Lift with flat carrier fixture
TOP LIFT 2.35 TSK = HYMAX Inground 2.35 B = Lift with lifting arms
TOP LIFT 2.35 TSA = HYMAX Inground 2.35 P = Lift with drive-on rails
For 2.35 TS (2.35 R) lifts, the extensions must be pulled out for longer vehicles so the vehicle can be safely
accepted at manufacturer-intended receiving points.
A standard lift may not be set up in explosion endangered spaces or wet environments.
2.3

Changes to the design / construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical
expert signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
2.4

Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist
signature).
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Name, address of technical expert
_________________________________________________
Location, date
OPI_TOP LIFT 2.35 TS TSK TSA - HYMAX INGROUND 2.35 R B P_V1.1_DE-EN-FR-ES-IT
_________________________________________________
Technical expert signature
_________________________________________________
Signature of expert for safety inspections
63