System Master Sheet; Manufacturer; Purpose - Nussbaum POWER LIFT HF 3000 Betriebsanleitung

2

System master sheet

2.1

Manufacturer

Otto Nußbaum GmbH & Co.KG
Korker Straße 24
D-77694 Kehl-Bodersweier
2.2

Purpose

The lift is a lifting tool for raising motor vehicles of a total weight or 3000 kg (HF 3000), 3500 kg (HF 3500) and
4000 kg (HF 4000) in normal workshop operation with a maximum load distribution of 2:3 (for HF 4000: Load
distribution 1:3) in the drive-in or against the drive-in direction. A single load from only one or two lifting arms
may not happen.
Set up of the standard lift in explosion endangered workshops and humid spaces (e.g. washing halls) is
prohibited.
Lift operation is done directly on the operating column (see Data sheet).
After construction and maintenance changes on load carrying parts the lift must be inspected afterwards
by a specialist who approves the changes. If the set up location is changed, the lift must be checked
again by a specialist and changed approved.
Load bearing capacity of the HF series
• HF 3000 = 3000 kg
• HF 3500 = 3500 kg
• HF 4000 = 4000 kg
Carrier arm variants
Standard arm
MINI-MAX arms (MM)
DT lifting arms
Sports car lifting arms
(SC)
OPI-POWER LIFT HF 3000-4000-HYMAX HF 3000-4000-V1.3-DE-EN-FR-ES-IT
HF 3000
590 – 900 mm
940 – 1495 mm
600 – 980 mm
1000 – 1480 mm
232SL28000TG
480 – 870 mm
940 – 1495 mm
–
HF 3500
505 – 823 mm
940 – 1495 mm
–
570 – 1160 mm
940 – 1495 mm
590 – 865 mm
840 – 1380 mm
HF 4000
570 – 1160 mm
1130 – 1840 mm
635 – 1065 mm
1130 – 1840 mm
–
–
65