Checking The Configuration - SICK Visionary-B Betriebsanleitung

8.2.4 Checking the configuration
8022960/186T / 2020-08-27| SICK AG
Subject to change without notice
NOTE!
For kit B, the configuration settings also have to be made for the second sensor head at
this point.
Click the asterisk or hash symbol to switch to the configuration of the second sensor
head and repeat steps 8 through 17.
22. Click the red cross in the top right-hand corner
Consider the boundary conditions (e.g., height, distance, etc.) specified in the tech-
nical data (see page 105).
1. If you have not already done so, switch the system on at the ignition.
2. Wait until the camera image appears on the display.
3. Check the alignment of the camera image (normal/flipped).
4. Press the "i" button.
NOTE!
Once you have pressed the button there is a short delay before the function is execut-
ed.
DANGER!
Risk of collision due to incorrect configuration.
Incorrect system configuration can result in collisions occurring without prior warning.
• The values for Estimated and Initial Height/Angle must be slightly different. If these
two values are identical, the sensor head has not been configured correctly and the
alarm will cannot be relied upon to trigger if the alarm zone is breached!
5. Test the configured values in setup mode and make any necessary adjustments
(see "8.3 Setup mode" on page
3 D S T R E A M I N G C A M E R A A N D D R I V E R A S S I S T A N C E S Y S T E M F O R A U T O M A T I O N
CONFIGURATION AND OPERATION
to complete the configuration.
100).
A N D C O L L I S I O N W A R N I N G | V I S I O N A R Y - B
9 9