Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.6
Mounting the system
5.6.1
Mounting the sensor head
5.6.2
Mounting the evaluation unit
5.6.3
Mounting the display
8022960/186T / 2020-08-27| SICK AG
Subject to change without notice
NOTE!
This needs to be done twice for kit B and kit C.
1.
First mount the sensor bracket. To do so, place the U-bracket on the base bracket
and screw them together. Make sure that the base support is oriented correctly.
2.
Carefully place the sensor head inside the U-shaped bracket at the top.
3.
Secure the sensor head by inserting and tightening the screws at the side.
4.
Adjust the installation angle of the sensor head and insert and tighten the two
screws at the rear to fix it in place.
5.
Fasten the sensor head cover and the supplementary bracket to the base bracket.
Optionally attach the supplementary bracket. The protective cap is designed for
use both with and without a supplementary bracket and can be stretched slightly if
necessary.
NOTE!
This needs to be done twice for kit C.
1.
Screw the mounting brackets to the evaluation unit.
2.
Once the evaluation unit has been attached to the mounting brackets, position the
unit and the brackets in the prepared location inside the driver's cab.
NOTE!
This needs to be done twice for kit C.
`
Carefully place the display inside the pre-mounted bracket.
3 D S T R E A M I N G C A M E R A A N D D R I V E R A S S I S T A N C E S Y S T E M F O R A U T O M A T I O N
MOUNTING
A N D C O L L I S I O N W A R N I N G | V I S I O N A R Y - B
8 5
Werbung
Kapitel
Inhaltsverzeichnis
