Setup Mode - SICK Visionary-B Betriebsanleitung

CONFIGURATION AND OPERATION
8.3

Setup mode

1 0 0
3 D S T R E A M I N G C A M E R A A N D D R I V E R A S S I S T A N C E S Y S T E M F O R A U T O M A T I O N
A N D C O L L I S I O N W A R N I N G | V I S I O N A R Y - B
6. Check that the image of the vehicle on the display, sensor head position, and
detection zone (shown on the right-hand side of the display) match the settings you
have made.
7. Check that the alarm is triggered when the alarm zone is breached
Any detected objects are represented by blue dots inside the displayed alarm zone.
NOTE!
For kit B, you can press the "g" pushbutton to switch between the individual sensor
heads without having to engage the corresponding gear.
NOTE!
If one of the checks is negative, you must repeat the configuration process for this
parameter.
8. Once you have completed the check, unplug the USB dongle and replace the cover
on the USB port.
NOTE!
In normal operation, the driver assistance system must not be used with USB devices
connected.
Setup mode can be activated by pressing the corresponding pushbutton shortcut in
"Operator mode". This operating mode is used to check configuration settings that have
been made and to make additional settings for "Operator mode".
Button Description
i Display / Hide system information
g Enable / Disable simulation of reverse / forward gear
r Toggle recorder status
F4 Display / Hide vehicle symbol and alarm zones
8022960/186T / 2020-08-27| SICK AG
Subject to change without notice