Preparing For Mounting; Planning For Mounting - SICK Visionary-B Betriebsanleitung

5.5

Preparing for mounting

5.5.1

Planning for mounting

8022960/186T / 2020-08-27| SICK AG
Subject to change without notice
2098103 Cable set for connecting the sensor head and evaluation unit
(15 m)
2098104 Cable set for connecting the sensor head and evaluation unit
(20 m)
2086211 Alarm cable for two discrete outputs, 0/12 V (5 m)
2098886 Ethernet cable for transmitting the Visionary-B streaming data (5 m)
NOTE!
When selecting a mounting location, please remember that the cables to the sensor
require sufficient space and must be easily accessible so that service work can be
carried out.
1. Locate the hazardous points on the vehicle in order to identify the best possible
location for the sensor head or heads. To assist you in making this decision, read
damage reports, talk to drivers, and inspect any existing evidence of damage to
the bodywork.
2. Check for space inside the driver's cab so that the evaluation unit(s) can be in-
stalled without inconveniencing the driver.
NOTE!
The evaluation unit must have sufficient space (approx. 10 cm) for heat dissipation.
Avoid enclosed areas in which heat can accumulate. Choose the mounting location
accordingly.
Ensure that the evaluation unit cannot be covered during operation (e.g., by coats,
covers, or similar).
3. Consult the driver when deciding where to position the display(s).
3 D S T R E A M I N G C A M E R A A N D D R I V E R A S S I S T A N C E S Y S T E M F O R A U T O M A T I O N
MOUNTING
A N D C O L L I S I O N W A R N I N G | V I S I O N A R Y - B
8 3