Preparing For Mounting - SICK Visionary-B Betriebsanleitung

MOUNTING
5.5.2

Preparing for mounting

8 4
3 D S T R E A M I N G C A M E R A A N D D R I V E R A S S I S T A N C E S Y S T E M F O R A U T O M A T I O N
A N D C O L L I S I O N W A R N I N G | V I S I O N A R Y - B
NOTE!
The evaluation unit and the display must be installed in a protected location, for exam-
ple inside the driver's cab. Also pay attention to the length of cable between the display
and evaluation unit.
4. Check where the cables can be laid. Avoid hot surfaces (e.g., exhaust pipes) when
laying the cables.
NOTE!
Include provision for additional lengths of cable that will be required for mobile driver's
cabs. For these applications, the cables must be laid "coiled" like a snake.
NOTE!
When mounting kit B and kit C, remember that sufficient space is required for mounting
additional components.


1. Select the mounting locations (1, 2, 3) as appropriate for the required detection
zone and the nature of the vehicle.
2. Use a mounting bracket and support that are capable of bearing the weight of the
sensor head.
NOTE!
The support must be able to bear the weight of the sensor head
real conditions.
3. Mount the prepared support on the vehicle as per your specific requirements (3).
4. Prepare the mounting location for the evaluation unit (2) inside the driver's cab by
drilling holes for the brackets and laying cable channels for the supply lines.
5. Install the bracket for the display inside the driver's cab (1).

8022960/186T / 2020-08-27| SICK AG
(see page 105) under
Subject to change without notice