Zone Configuration Options; Configuring The Visionary-B; Important Notes; Symbols On The Hmi Controller - SICK Visionary-B Betriebsanleitung

CONFIGURATION AND OPERATION
8.1.2 Zone configuration options
8.2 Configuring the Visionary-B
8.2.1

Important notes

8.2.2

Symbols on the HMI controller

9 2
3 D S T R E A M I N G C A M E R A A N D D R I V E R A S S I S T A N C E S Y S T E M F O R A U T O M A T I O N
A N D C O L L I S I O N W A R N I N G | V I S I O N A R Y - B
Configuration Zone 1
1 Object class 1
2 Object class 1
3 Object class 2
4 Object class 1
5 Object class 2
6 Object class 3 and /or 4 and /or 5 Object class 3 and /or 4 and /or 5
7 Object class 3 and /or 4 and /or 5 n/a
NOTE!
Only trained personnel are permitted to configure the driver assistance system.
Disconnect the mouse and keyboard once configuration is complete.
The driver assistance system can only be configured with the system fully connected
and the vehicle at standstill.
Pre-configuration is only possible if the installation height and angle have been pre-
cisely defined in advance and the sensor head has been mounted as described in
these instructions.
If these steps are not followed correctly detection errors may occur, thereby creating
hazards while the driver assistance system is in use.
A USB keyboard and mouse (e.g., a wireless USB kit) are required to configure the
system.
Both sensor heads have to be configured for each of kits B and C. The configuration
process is largely identical to that for kit A. Your attention is drawn to any specific differ-
ences.
Symbol Function
Select operating mode
Reset the configuration
Center view on vehicle model and reset zoom
Enlarge view (zoom in)
Reduce view (zoom out)
Zone 2
Object class 1
Object class 2
Object class 1
n/a
n/a
8022960/186T / 2020-08-27| SICK AG
Subject to change without notice