Inserting The Drive Battery In The Vehicle; F) Connecting The Drive Battery To The Speed Controller - Reely Bulldog Bedienungsanleitung

e) Inserting the drive battery in the vehicle
Attention!
The drive battery must not yet be connected to the speed controller. First switch on the transmitter, see
section 9. c) and 9. d).
Important!
This vehicle is suitable for use with a LiPo drive battery with 2 cells (nominal voltage 7.4 V) or a NiMH drive
battery with 6 cells (nominal voltage 7.2 V). A 2-cell LiPo drive battery is included with item no. 1605713.
When using a drive battery with more cells, there is a danger of fire resulting from the speed controller
overheating. In addition, the vehicle's drive will be overloaded and thus damaged (e.g. differential). This will
void the warranty.
Loosen the two hook-and-loop straps (A) on the battery
holder.
Then insert the drive battery into the battery holder (B).
If the battery's connection cable is very short, the battery
must be inserted into the battery holder with connection
cable pointing forward.
Pull the two hook-and-loop straps (A) tight so that the drive
battery is firmly held in place and fasten the hook-and-loop
strap.

f) Connecting the drive battery to the speed controller

First switch off the speed controller. To do this, switch the
on/off switch (see the arrow in the picture to the right) to
the "OFF" position. Observe the labels next to the slide
switch.
Set the trim for the steering and driving functions on the
transmitter in the central position.
In order to prevent the wheels from starting
suddenly and the vehicle driving away uncon-
trolled, place the model vehicle on a suitable
base (or a start box) so that the wheels can
move freely in case of a fault.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity when doing this (red cable = plus/+,
black cable = minus/-).
42
Downloaded from www.Manualslib.com manuals search engine