Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
e) Inserting the Drive battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. c) and d).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH/NiCd drive battery with 6 cells (nominal voltage 7.2 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. main pinion). Loss of gua-
rantee/warranty!
To insert the drive battery, pull out the safety clips (2) first.
Then remove the retainer (1) from the vehicle.
Insert the drive battery into the battery holders.
Reinsert the retainer and reattach it with the safety clips
removed in the beginning.
f) Connecting the Drive battery to the Speed Controller
First switch off the speed controller. The on/off switch is
at the bottom of the chassis, right next to the motor, see
figure on the right.
To switch it off, move the slider (1) away from the speed
controller („OFF").
Then switch on the transmitter if you haven't done so yet
(see chapter 9. c) and d).
To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the trim-
ming for the drive is maladjusted), place the model vehicle on a suitable support (or starting box), so that the
wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable = mi-
nus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.
1
2
1
2
47
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
