Operation; Inserting Batteries Into The Remote Control; Inserting The Drive Battery In The Vehicle - Reely 1590615 Bedienungsanleitung

9. Operation

a) Inserting batteries into the remote control
• Switch off the transmitter using the on/off switch (A) ("OFF" = off).
• Unscrew the screw (G) on the battery compartment lid (F) with a suitable screwdriver.
• Then carefully flip the battery compartment lid (F) up.
• Insert a 9 V block battery into the battery compartment, ensuring that the polarity is correct (pay attention to the
positive/+ and negative/- poles, see the information in the battery compartment and on the battery).
• Close the battery compartment, close the battery compartment cover (F) to. Then screw the screw (G) tight again
(do not use force!).
When using a rechargeable battery, the operating time is reduced. For safety reasons, we recommend
using an alkaline battery instead of a rechargeable battery.
b) Inserting the drive battery in the vehicle
• Turn the vehicle first using the on/off switch (H)
on the bottom ("OFF" = switched off).
• Unscrew the screw (I) on the rechargeable bat-
tery compartment cover with a suitable screw-
driver and remove it.
• Connect the drive battery to the appropriate plug
(J) on the vehicle until the plug clicks into place.
The plug and socket are protected against polar-
ity reversal by their special shape.
Do not use force when connecting the drive
battery. The plug can be connected with very little
force.
• Insert the drive battery in the battery compartment and replace the cover, so that it can be closed correctly. Then
screw the screw (I) tight again (do not use force!).
27