Reely Bulldog Bedienungsanleitung Seite 54

The drive function runs opposite to the direction of the throttle/brake lever on the transmitter
• Usually, the vehicle should move forwards when the throttle/brake lever on the transmitter is pulled towards the
handle.
• If this is not the case, activate the reverse setting for the drive function on the transmitter.
• If the motor is disconnected from the speed controller (e.g. for maintenance purposes) and then subsequently re-
connected, the motor cables could have been mixed up. Swap two of the three motor cables with one another. This
reverses the rotational direction of the brushless motor.
The steering is not functioning or is not functioning correctly, steering angle on the vehicle is too low
• If the transmitter has a dual rate setting, check it (see the operating instructions for the transmitter). If the dual rate
setting is too low, the steering servo will no longer react.
• If the transmitter has a setting for the servo endpoints (e.g., with EPA, endpoint adjustment), check and correct it.
• Check the steering mechanism for loose parts, check e.g. whether the servo arm is attached correctly to the servo.
The drive battery heats up during charging and when driving the vehicle
• This is normal.
54
Downloaded from www.Manualslib.com manuals search engine