Inserting The Drive Battery In The Vehicle; F) Connecting The Drive Battery To The Speed Controller - Reely DT5 BL RtR Bedienungsanleitung

e) Inserting the Drive battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. c) and d).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH drive battery with 6 cells (nominal voltage 7.2 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed controller.
Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of guarantee/
warranty!
Remove the two hook-and-loop tapes of the battery holder. Place the drive battery into the battery holder and fasten it
with the two hook-and-loop tapes. Tighten the hook-and-loop tapes to secure the drive battery.

f) Connecting the Drive battery to the Speed Controller

First switch on the transmitter, as described in chapters 9. c)
and d).
Switch off the speed controller.
Put the On/Off switch (see arrow in the figure to the right)
into the „OFF". Push the switch away from the setup button
for this.
To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the trimming
for the drive is maladjusted), place the model vehicle on a suitable support (or mounting stand/car stand), so
that the wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable =
minus/-).
38