GE VAT300 Kurzanleitung Seite 30

5-2 Block-A parameters
No.
A00 – Frequency setting
0 Local frequency setting
1 Jogging frequency
A01 – Acceleration/deceleration time
0 Acceleration time – 1
1 Deceleration time – 1
A02 – Torque boost
0
1
2
3
4
5 Slip compensation gain
6
A03 – DC Brake
0 DC braking voltage
1 DC braking time
2 DC braking current
Downloaded from www.Manualslib.com
Parameter Min.
0.10
0.10
0.1
0.1
Manual torque boost
1.
selection
Automatic torque boost
1.
selection
Manual torque boost
0.00
setting
Square reduction torque
0.00
setting
R1 drop compensation
0.0
gain
0.00
Maximum torque boost
0.00
gain
0.01
0.0
0.
manuals search engine
Default
Max.
(Unit)
10.00 This is the frequency set from the operation
Max.
(Hz) panel.
fre-
5.00
quency
This is the frequency setting for jogging.
(Hz)
10.0 The value can be displayed in units of 0.1
6000.0
(s) or 10 times as set on B10-5.
The time to reach the max. frequency or
20.0
6000.0
max. speed from 0 is set.
(s)
2. 2. 1: Disable = 2: Enable
2. 1. 1: Disable = 2: Enable
Inverter Set the boost voltage at 0Hz.
20.00 rating This is automatically adjusted by the
(%) automatic tuning.
0.00 Set the reduced
25.00
(%) frequency/2.
Set how much to compensate the voltage
100.0
100.0 drop caused by R1 measured with
(%)
automatic tuning.
Set the motor's rated slip.
0.00
20.00 This is automatically adjusted by the
(%)
automatic tuning.
This is automatically adjusted by the
0.00 automatic tuning. The optimum boost
50.00
(%) amount for outputting the maximum torque
is set.
This is automatically adjusted by the
Inverter
automatic tuning. When setting manually,
20.00 rating
monitor the output voltage and change the
(%)
setting in increments of 1% or less.
2.0
20.0 Set the time to apply the DC brakes.
(s)
This is used instead of the DC brake
50.
150. voltage in the vector mode and PM mode.
(%)
This is not adjusted with automatic tuning.
EN-28
Change is
Function possible during
operation.
voltage at Base