GE VAT300 Kurzanleitung Seite 17

1) Control terminal TB1,TB2
2) Dip switches DS1
3) EL-BIT W1,W2,W3,W4
4) Standard serial or Modbus transmission
5) Standard serial or Modbus transmission TB3
Downloaded from www.Manualslib.com
・The terminal block is laid out in two rows.
・Terminal screw size is M3.
No. OFF
1 OPEN
120Ω
2 V1
3 V2
4 PS03 PULSE
１
No.
W1 SINK SOURCE PSI1～6 sink，source changeovers
W2 SINK SOURCE PSI7 sink，source changeover
W3 voltage current
W4 voltage current
CN2 (Connector type: 4-pole modular, Hirose Electric TM3P-44P or equivalent)
・A signal level is based RS-485. The terminus resistance (120Ω) can set up on/off in DS1-1.
((DS1-1=120Ω): Connected, (DS1-1=OPEN): Not connected)
・The direction of a signal is based on VAT300.
・5VOP and 0VOP are not designed to supply power to any external devices.
Terminal
Signal
No.
1 DATA+
2 DATA-
3 0VOP
4 5VOP
・CN2 and TB3 DATA+, DATA- and 0VOP are connected in the PCB.
・The terminal size is M2.
・The applicable wire size is AWG26 to AWG16.
Terminal
Symbol
No.
1 D+
2 D-
3 SG
manuals search engine
ON Signal
Standard serial terminator changeover
I1 AI1 voltage, current changeover
I2 AI2 voltage, current changeover
Sequence output, pulse train output changeover
２
Signal
AO1 voltage, current changeover
AO2 voltage, current changeover
Outline drawing of connector
Signal
DATA+
DATA-
0VOP
EN-15
All switches are
set to OFF as the
default.
All EL-BITs are
set to 1 as the
default.
5mm
7.7mm
6.6mm
Wire peeling size
5mm
4
3
2
1