GE VAT300 Kurzanleitung Seite 27

9) Move the digit with the
10) Press the
11) Press the
This completes the test operation with the operation panel.
After this, refer to Chapter 5 and carry out the settings and adjust the load operation to match the
user's application.
Downloaded from www.Manualslib.com
the frequency to 50.00Hz. Then, press the
(Note) The operation panel frequency change operation is set to "Change in real time"
(C11-2=1) with the factory shipment settings. Thus, even if the
pressed, the frequency will change in real time using the
( knob with U30 V24OP1).
LCL
When the
SET
A 10-second acceleration and 20-second deceleration ramp time are set as defaults. The motor
will slowly increase its speed to the set value.
When making a setting (using the
check that the motor operates correctly at each increment of approx. 10Hz.
RST
key several times, and display D00-0. When the output frequency ("D00-0"
MOD
display) reaches 50Hz, press the
The display will decrease to "0.00" in several seconds. The "FWD" or "REV" LED will flicker for
two seconds while the DC-brake is applied and the motor will stop.
key, and test the reverse run at 50Hz.
(Note) Do not carry out this step if a load which cannot be run in reverse is connected.
manuals search engine
key, and using the key (
LCL
key. The output frequency will rise to 50Hz.
SET
key is pressed, the current setting value will be saved.
CAUTION
keys, or
STOP
key.
EN-25
knob with U30 V24OP1), raise
LCL
key is not
SET
keys
knob with U30 V24OP1),