20
21
22
6.8 Only for Genium: preparing the charging unit
Complete the following steps to assemble the charging unit for the Genium:
42
2) Cut off the sheath at the top with an over
hang of 6 cm.
3) Secure the sheath on the inside all around
on the proximal end of the foam with con
tact adhesive.
INFORMATION: Note the setting time
of the contact adhesive depending on
the application thickness and temper
ature.
4) Fold over the distal end of the sheath and
slide it into the recesses of the tube
adapter.
INFORMATION: The sheath must not be
glued or cut off in the ankle area.
5) Punch the 4 holes for the tube adapter
screws in the sheath as well.
INFORMATION: Before punching, apply
contact adhesive to the corresponding
areas to prevent runs in the sheath.