Ottobock 3F1-1 Gebrauchsanweisung Seite 35

1
2
3
4
1) Loosen the screws on the functional knee
part.
2) Slightly expand the functional knee part
and pull it over the frame of the joint.
3) Secure the position of the upper knee part
with the Allen key size 2.
NOTICE! This secures the upper knee
part in the required position.
4) Fully extend the knee joint with the
assembled socket.
INFORMATION:
extender has to be used with the C-Leg.
5) Check the upper knee part and the ball top
for collisions with the socket.
6) Mark the collision points on the upper knee
part and ball top.
7) If necessary, separate the upper knee part
from the lower knee part for processing.
Push the two blind plugs out of the clips
from the outside to the inside using an
Allen key size 2.
The 4H105 knee
35