Manual Cutting; Combining Manual And Automatic Operation - struers Discotom 65 Gebrauchsanweisung

Manual Cutting

Combining Manual and
Automatic Operation
26
Discotom-60 /-65
Instruction Manual
 Clamp the workpiece.
 Loosen the locking handle on the right side of the cutting
chamber.
 Position the cutting table and the workpiece under the cut-off
wheel with the Y-table joystick.
 Close the protection guard.
 Ensure that Manual Cutting mode is selected .
 Press the start button
starts rotating and the cooling water is turned on.
 Pull down the cutting handle and let the cut-off wheel work itself
into the workpiece. Increase the pressure and begin cutting.
 When the cut-off wheel has almost cut through the workpiece
reduce the pressure.
 When the cut-off wheel has cut through the workpiece push the
cutting handle back to its top position.
 Press the stop button
When cutting manually, the motor load information should be used
to monitor the force on the workpiece.
Manual and Automatic cutting modes may be used in combination.
 Cut into the workpiece in Manual mode.
 Secure the locking handle in this position, select Automatic
Cutting mode and continue in Automatic mode; the workpiece will
move towards the cut-off wheel.

to start the machine. The cut-off wheel

to stop the machine.
IMPORTANT