Manual Cutting - struers Discotom-6 Gebrauchsanweisung

Manual Cutting

14
Discotom-6
Instruction Manual

Clamp the workpiece.

Loosen the small black handle on the right side of the cutting
chamber. The cutting handle is now easily moved up and down.

Position the cutting table and the workpiece under the cut-off
wheel with the FORWARDS

Close the protection guard.

Make sure that AUTO MODE is de-selected.


Press START
rotating and the cooling water is turned on.

Pull down the cutting handle and let the cut-off wheel work itself
into the workpiece. Increase the pressure and begin cutting.

When the cut-off wheel has almost cut through the workpiece
reduce the pressure.

When the cut-off wheel has cut through the workpiece push the
cutting handle back to its top position.


Press the STOP key to stop the machine
When cutting manually, the motor load bar should be used to monitor the
force on the workpiece. Try to keep the motor load in the green or the

and BACKWARDS
to start the machine. The cut-off wheel starts
Remember
beginning of the yellow area.

keys