Error Messages - struers Discotom 65 Gebrauchsanweisung

Error Messages

Messages
Errors
Message/Error
Start denied, process
menu not selected
Are you sure you want
to change pass code?
Protection hood not
closed!
Close the hood and
press the menu button
.
Discotom is searching
for reference position,
please wait
The reference position
is found, Discotom is
ready.
Cutting finished, stop
position reached
Discotom-60 /-65
Instruction Manual
Error messages are divided into two classes:
Messages
Errors
Messages are intended to inform the operator of the machine's
progress and advise about minor operational errors.
Errors must be rectified before cutting can be continued.
In some cases, cutting cannot continue before an authorised
technician has rectified the error. Turn off the unit at the Main Switch
immediately. Do not attempt to operate unit before a technician has
rectified problem.
Type Explanation
The start button  was
MESSAGE
(#0) pressed in a menu where
it's not possible to start
cutting
MESSAGE
(#2)
MESSAGE The cutting chamber
(#3) hood was open when the
Discotom was switched
on.
MESSAGE
(#4)
MESSAGE
(#5)
MESSAGE
(#6)
Action
Return to the Cutting menu, ensure that all
cutting parameters are set to an appropriate
value, press start button  again to begin
cutting.
Press the menu button  to accept the new
pass code. Press  button to reject the
new pass code and continue to use the
current one.
Close the hood and press the menu button
.
Wait until the reference position has been
found and the display changes.
On every 10th start up, Discotom will
perform an extended reference routine
during which the Y-table will be moved fully
forward and backward. This is to ensure that
the table's tracks are kept clean.
47