Connecting A Recirculation Cooling Unit - struers Discotom 65 Gebrauchsanweisung

Connecting a Recirculation
Cooling Unit
A
B
Drainage Hose
Discotom-60 /-65
Instruction Manual
To ensure optimal cooling, Discotom can be fitted with a Cooli unit.
Cooling System 5 is a Cooli configuration designed for use with
Discotom.
Cooling System 5 includes a static filter.
For intensive use, and for materials generating a lot of swarf,
a bandfilter such as Coolimat-200 is recommended.
Before connecting the cooling unit to the Discotom, follow the instructions in
the Cooling Units Instruction Manual to prepare it for use.
To connect the Discotom to a Recirculation Cooling Unit:
 Plug the Cooli control unit's communication cable into the
Discotom's control socket.
 Connect the water inlet hose to the Cooli pump using the quick
coupling (A).
 Connect the other end of the hose to the Discotom water inlet.
 Insert the connector pipe  in the water outlet on the back of
Discotom and mount the 90° elbow pipe . Lubricate the sealing
ring with grease or soap to facilitate insertion. (Use the other
elbow pipe if more suitable).
 Mount the outlet hose  onto the elbow pipe and clamp using a
hose clamp.
 Check that the outlet hose slopes downwards when connected. If
necessary adjust the length of the hose.
 Insert the other end of the hose into the mounting hole in the
bracket on top of the Cooli filter unit (B).
 Connect the cooling unit to the mains power supply.
Before connecting, check that the mains voltage corresponds to the voltage
stated on the type plate on the side of the machine.
 Place the drainage hose in the tank of the Cooling Unit or lead to
drain.
Note:
Note
IMPORTANT
9