General Operating Instructions; Idle State; Cooking Chamber Light; Opening The Cooking Chamber Door - hanseatic AC928A2CA Gebrauchsanleitung

Page EN-14

General operating instructions

General operating instructions

Idle state

The appliance is in an idle state when the
cooking chamber door is locked, the light in
the cooking chamber is not lit, and the display
shows the current time.
If the time is not set (at initial start-up or when
the appliance has been disconnected from
the mains), the display will permanently show
0: 0 0 when idle.
When eco mode is activated, the dis-
play remains off in sleep mode (see
'Eco mode' on page EN-33).

Cooking chamber light

The cooking chamber light switches on auto-
matically when
– the appliance is in operation or has been
paused.
– the cooking chamber door (8) is open.
Opening the cooking
chamber door
When you open the cooking chamber door (8)
during operation, the appliance goes to idle/
pause.
After you close the cooking chamber door
again, the appliance will resume operation
only when you press the

Control dial

Using the control dial (4) you can select the
cooking time, weight or automatic programme
according to the selected operating mode.

Clock

The integrated clock is used for displaying the
time, to automatically stop the cooking pro-
cess and as a timer.
The date is always shown in 24-hour format.
Setting the time
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Press the 'Timer/Time' button (22) twice.
2. Turn the control dial (4) until the current
3. Press the 'Timer/Time' button again to
4. Turn the control dial until the current min-
5. Press the 'Timer/Time' button again to
switch back to idle mode.
Changing the time
To change the time (e.g. when changing from
GMT to BST), follow the steps described in
'Setting the time' on page EN-14.
button (25).
and from daylight saving hours.
The display will show a flashing hour indi-
cator.
hour is reached.
confirm the setting.
The minute display will flash.
ute is reached.
confirm the setting.
This then sets the current time.
To stop setting the time, press the
button (26). The appliance will then
You must manually enter the time
changes that occur when switching to