Timer Function; Safety Lock (Child Safety Lock); Switching Beeps On/Off; Function Query - hanseatic AC928A2CA Gebrauchsanleitung

Timer function

The timer function can be used like an egg
timer. The appliance's cooking function will
not be activated.
Requirement: No cooking process can be
active.
1. Press the 'Timer/Time' (22) button. A beep
will sound. 00: 0 0 will then appear on the
display as the time.
2. Use the control dial (4) to set the desired
time (max. 95 minutes).
You can set the time in the following steps:
Area Steps
0–1 min 5 seconds
1-5 min 10 seconds
5–10 min 30 seconds
10-30 min 1 minute
30-95 min 5 minutes
3. Push the button (25) to start the timer.
A countdown will begin from the set time.
5 beeps will sound after the time has ex-
pired.
You can stop the timer in advance:
• Press the button (26).
A beep will sound. The clock time will reap-
pear on the display, and the appliance will
be fully functional again.

Safety lock (child safety lock)

If the safety lock (child safety) is activated,
then all buttons including the function selector
will not work.
Activating/deactivating the safety lock
• Press and hold the
prox. 3 seconds.
General operating instructions
button (26) for ap-
20 30
A beep will sound and the
will appear or disappear on the display.
Activating the safety lock is only pos-
sible when the appliance is in sleep
mode.

Switching beeps on/off

• Press and hold the
button (25) for approximately 3 sec-
onds.
A beep will sound, and all beeps will then
be switched off or on.
If you turn off the beeps, there will
no longer be any beeps at the end of
cooking or any beep to indicate that the pre-
heating temperature has been reached.

Function query

– You can check the time during the cooking
process by pressing the 'Timer/Time' but-
ton (22) .
The time display then switches back auto-
matically to the cooking display.
– You can check the power level during the
cooking process by pressing the 'Heating
mode' button.
The power level display then switches back
automatically to the cooking display.
Page EN-15
symbol (14)
button (26) and the