Symbols Used; Operating States/Error Signals; Warnings/Error Signals - Ottobock DynamicArm 12K100N Gebrauchsanweisung

12 Appendices

12.1 Symbols Used

Declaration of conformity according to the applicable European directives
Manufacturer
Compliance with the requirements according to "FCC Part 15" (USA)
In some jurisdictions it is not permissible to dispose of these products with unsor­
ted household waste. Disposal that is not in accordance with the regulations of
your country may have a detrimental impact on health and the environment. Please
observe the instructions of your national authority pertaining to return and collec­
tion.
Compliance with the requirements under the "Radiocommunications Act" (AUS)
Serial number
Non-ionising radiation

12.2 Operating states/error signals

12.2.1 Warnings/error signals

Beep signal
1 x long
1 x long
2 x
Vibration signal
1 x
5 x
1 x
Error
Critical error
(e.g. a sensor is not
operational)
Severe error
(e.g. temperature of
the lifting motor too
high)
Malfunction
(e.g. incompatible
component connec­
ted)
Required action
Turn the product off
and on again or, with
the product turned on,
connect the battery
charger. Contact
Ottobock Service if
the error has not been
resolved.
25