Stryker Power-PRO 6385 Bedienungsanleitung Seite 15

N N o o t t e e - - Adjust the track mounted fasteners (Unwin adaptors), as needed to fit into the tracks.
12. Retighten the screws after aligning the locks with the floor tracks.
N N o o t t e e - - Track mounted fastener (Unwin adaptor) supplied by Unwin Safety Systems.
I I n n s s t t a a l l l l i i n n g g t t h h e e h h e e a a d d e e n n d d a a n n d d f f o o o o t t e e n n d d f f a a s s t t e e n n e e r r ( ( M M o o d d e e l l 6 6 3 3 8 8 8 8 a a n n d d 6 6 3 3 8 8 9 9 ) )
T T o o a a s s s s e e m m b b l l e e b b o o t t h h c c o o t t f f a a s s t t e e n n e e r r s s : :
1. Position the four supplied lock down washers (6388-001-080) (W) between the track mounted fastener (NMI adaptor)
(V) and the foot end fastener lock down base plate (X) (Figure 9).
2. Loosely tighten the wing nuts (U) to attach the track mounted fastener (NMI adaptor) (V) to the foot end fastener lock
down base plate (X) (Figure 9).
3. Repeat steps 1-2 to attach the track mounted fastener (NMI adaptor) to the head end fastener lock down plate.
W
T T o o i i n n s s t t a a l l l l b b o o t t h h c c o o t t f f a a s s t t e e n n e e r r s s : :
4. Identify the location for the foot end fastener and head end fastener from Figure 10 for Model 6388 and Figure 11 for
Model 6389.
5. Unlock the track mounted fastener (NMI adaptor) (V) of the foot end fastener (AB) by pulling the pin (AA) to unlock
(Figure 9).
6. Pull the handle (Z) and then the wedge (Y) up to open (Figure 9).
7. Align the foot end fastener (AB) in the floor track (Figure 9).
8. Lock the track mounted fastener (NMI adaptor) (V) to the floor track by folding the wedge (Y) and then the handle (Z)
down to close (Figure 9).
9. Tighten the wing nuts to securely attach the track mounted fastener (NMI adaptor) (V) to the foot end fastener lock down
base (X) (Figure 9).
10. Repeat steps 5-7 to install the head end fastener on the floor track (Figure 5).
11. Make sure that the fastener spacing matches Figure 6.
12. Loosen the two wing nuts on either side of the fastener that attach the locks to the lock down base plate.
N N o o t t e e - - Adjust the track mounted fasteners (Unwin adaptors), as needed to fit into the tracks.
N N o o t t e e - - Track Mounted Fasteners (NMI Adaptors) supplied by NMI Safety Systems.
6385-109-005 Rev A.0
U
V
X
F F i i g g u u r r e e 9 9 – – A A s s s s e e m m b b l l e e t t h h e e f f o o o o t t e e n n d d f f a a s s t t e e n n e e r r
Y
Z
AA
AB
11 EN