Stryker Power-PRO 6385 Bedienungsanleitung Seite 12

610 MM (REF)
D
A Head end
B Foot end
C Front of vehicle
3. Cut 1 in. x 2-1/2'' x 9/16'' deep recessed openings (F) into the floor centered over the locating holes (Figure 3).
4. Using two 3/8'' diameter (grade 8) socket head cap screws (G), anchor each floor plate (H) into the recessed openings
with the counter-bored holes facing up (Figure 4).
N N o o t t e e
• Steel backing plates (or equivalent) (I) (not supplied) are required for added support (Figure 4).
• For the foot end, use four steel backing plates with dimensions 4" x 6" x 3/8". For the head end, use one steel backing
plate with dimensions 9.25" x 10" x 3/8".
• If the steel backing plate is not threaded, use a washer and 3/8"-16 locking nut on each.
F F i i g g u u r r e e 3 3 – – C C u u t t r r e e c c e e s s s s e e d d o o p p e e n n i i n n g g s s o o v v e e r r l l o o c c a a t t i i n n g g h h o o l l e e s s
Recessed opening
F
Socket head cap screw
G
Floor plate
H
EN 8
A
90 MM
C
320 MM 150
F F i i g g u u r r e e 2 2 – – F F l l o o o o r r p p l l a a t t e e i i n n s s t t a a l l l l a a t t i i o o n n l l o o c c a a t t i i o o n n s s
1925 MM (REF)
E
140 MM
1015 MM
D Cot width
Cot length
E
F F i i g g u u r r e e 4 4 – – A A n n c c h h o o r r f f l l o o o o r r p p l l a a t t e e i i n n t t o o r r e e c c e e s s s s e e d d o o p p e e n n i i n n g g s s
Steel backing plate
I
Plywood
J
Flooring
K
B
120 MM
194 MM
6385-109-005 Rev A.0