Stryker Power-PRO 6385 Bedienungsanleitung Seite 17

AE
AF
O O p p e e r r a a t t i i o o n n
L L o o a a d d i i n n g g a a c c o o t t i i n n t t o o t t h h e e f f a a s s t t e e n n e e r r
W W A A R R N N I I N N G G - - Do not use hand or fingers to press down on the release lever when the hooks are open. The fastener closes
with a strong spring action.
C C A A U U T T I I O O N N
• Always make sure that the cot is in the lowest height position before you load the cot into the fastener. Press the retract
(-) button until the cot stops moving down to make sure that the cot will properly lock into the fastener.
• Do not press the extend (+) button while the cot is secured into the fastener to avoid injury and product damage.
1. Depress the pedal and make sure that the cot is in the lowest height position before you load the cot into the fastener
(Figure 12).
N N o o t t e e - - To make sure that the cot is in the lowest position, press the retract (-) button until the cot stops moving
downward.
2. Guide the cot into the head end and foot end fasteners until the locking mechanism is secure (Figure 13).
6385-109-005 Rev A.0
1244.6 MM
AE
F F i i g g u u r r e e 1 1 1 1 – – F F l l o o o o r r t t r r a a c c k k i i n n s s t t a a l l l l a a t t i i o o n n l l o o c c a a t t i i o o n n s s
F F i i g g u u r r e e 1 1 2 2 – – P P e e d d a a l l f f u u l l l l y y d d e e p p r r e e s s s s e e d d
AF
49 positions
Locks use indicated track positions
300 MM
13 EN