Setting Remote Control Id - Yamaha RXV-1700 Bedienungsanleitung

ADVANCED SETUP
■ Bi-AMP
BI-AMP
Use to activate or deactivate the bi-AMP function.
Choices: ON, OFF
• Select "ON" if you want to activate the bi-AMP
function.
• Select "OFF" if you want to deactivate the bi-AMP
function.
Note
When BI-AMP is set to ON, the SURROUND BACK terminals
cannot be used to connect surround back speakers in that the
SURROUND BACK terminals are already used for the bi-AMP
connection (see page 17).
■ Video reset
VIDEO RESET
Use to initialize the parameter settings for "DISPLAY
SET" in "OPTION MENU" (see page 90).
Choices: YES, CANCEL
Note
The parameter setting for "DIMMER", "SHORT MESSAGE",
"ON SCREEN" and "FL SCROLL" is not initialized (see
page 90).
112
En

Setting remote control ID

hen using multiple YAMAHA receivers/amplifiers, you
W
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
■ Setting remote control AMP ID
1
Set the operation mode selector to AMP or
SOURCE.
AMP
SOURCE
TV
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
then press l / h repeatedly until "L;AMP"
appears in the display window on the remote
control.
LEARN
Notes
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, start over from step 1.
3
Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
A/B/C/D/E
AMP
SOURCE
or
TV
PRESET/CH
ENTER
A/B/C/D/E
PRESET/CH
ENTER