Dynamic Range - Yamaha RXV-1700 Bedienungsanleitung

GEQ
Graphic equalizer
Use to match the tonal quality of the center, surround L/R
and surround back L/R, surround back, presence L/R
speakers and the subwoofer with that of the front L/R
speakers. You can adjust 7 frequency bands (63Hz,
160Hz, 400Hz, 1kHz, 2.5kHz, 6.3kHz, 16kHz).
Choices: –6.0 to +6.0 dB
Control step: 0.5 dB
A)EQUALIZER
. CHANNEL;;FRONT L
-______+
63Hz ;;;;;;
160Hz ;;;;;;
400Hz ;;;;;;
[ ]/[ ]:Up/Down
p [
[ ]/[ ]:Adjust
y
Press k / n to select a frequency band and l / h to adjust the
selected frequency band.
Note
The "GEQ" parameter can be adjusted only when "GEQ" is
selected in "SELECT".
TEST TONE
Test tone
A)EQUALIZER
CHANNEL;;FRONT L
-______+
16kHz ;;;;;;
. TEST TONE;;;;OFF
[ ]/[ ]:Up/Down
p [
[ ]/[ ]:Adjust
Use this feature to make adjustments of "GEQ" while
listening to a test tone. To select "TEST TONE", press n
repeatedly in the graphic equalizer screen.
Choices: OFF, ON
• Select "OFF" to stop test tones and output the currently
selected source component.
• Select "ON" to output test tones from the selected
speakers.
■ Low-frequency effect level
Use this feature to adjust the output level of the LFE (low-
frequency effect) channel according to the capacity of
your subwoofer or headphones. The LFE channel carries
low-frequency special effects which are only added to
certain scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Control range: –20 to 0 dB
Control step: 1 dB
0.0dB
0.0dB
0.0dB
Speaker SPEAKER
Adjusts the speaker LFE level.
Headphone HEADPHONE
Adjusts the headphone LFE level.
Note
Depending on the settings of "LFE/BASS OUT" (see page 80),
some signals may not be output at the SUBWOOFER OUTPUT
0.0dB
jack.

■ Dynamic range

Use this feature to select the amount of dynamic range
compression to be applied to your speakers or
headphones. This setting is effective only when this unit is
decoding Dolby Digital and DTS signals.
Choices: MIN, STD, MAX
• Select "MIN" (minimum) if you regularly listen at low
• Select "STD" (standard) for general use.
• Select "MAX" (maximum) to preserve the greatest
Speaker SP
Adjusts the speaker compression.
Headphone HP
Adjusts the headphone compression.
CUSTOMIZING THIS UNIT (MANUAL SETUP)
B)LFE LEVEL
B)LFE LEVEL
. SPEAKER;;;;;;0dB
HEADPHONE;;;;0dB
[ ]/[ ]:Up/Down
p [
[ ]/[ ]:Adjust
C)DYNAMIC RANGE
volume levels.
amount of dynamic range.
C)DYNAMIC RANGE
. SP: MIN STD MAX
HP: MIN STD MAX
[ ]/[ ]:Up/Down
p [
[ ]/[ ]:Select
[
[
85
En